Home › Resource Center › Logbooks and maintenance records

Annual inspection logbook entry: what it must say

Updated November 19, 2026 · About a 6-minute read

The annual inspection entry is the one a ramp inspector, an insurer or a buyer looks at first. The FAA spells out what it has to contain, almost word for word. Here's what to check when you get your logbooks back, with the FAA source for each rule at the bottom.

Covers annual and 100-hour inspections of type-certificated aircraft under Part 91. Progressive inspections and other inspection programs have their own entry rules. Not legal advice.

When it's due and who can do it

  • Annual: no one may operate the aircraft unless, within the preceding 12 calendar months, it has had an annual inspection and been approved for return to service by a person authorized under 14 CFR 43.7 (14 CFR 91.409(a)). For most owners that's a mechanic with an Inspection Authorization, which is what allows an A&P to perform an annual (14 CFR 65.95).
  • 100-hour: also required (an annual counts as one) when the aircraft carries people for hire, or when someone gives flight instruction for hire in an aircraft they provide (91.409(b)). A mechanic with airframe and powerplant ratings can do a 100-hour (14 CFR 65.85 and 65.87). A 100-hour counts as an annual only if a person authorized to do annuals performs it and it's entered as an annual (91.409(a)).

What the inspection has to include

  • The inspector must use a checklist that includes at least the scope and detail of 14 CFR Part 43, Appendix D (43.15(c)(1)).
  • Before approving a piston-engine aircraft for return to service, the inspector must run the engine to check power output (static and idle rpm), magnetos, fuel and oil pressure, and cylinder and oil temperature against the manufacturer's recommendations (43.15(c)(2)).
  • The inspection must determine whether the aircraft meets all applicable airworthiness requirements (43.15(a)), which FAA guidance says includes AD compliance (AC 39-7D).

What the entry must contain (14 CFR 43.11(a))

  1. The type of inspection and a brief description of its extent.
  2. The date of the inspection and the aircraft total time in service.
  3. The signature, certificate number and kind of certificate of the person approving or disapproving the aircraft for return to service.
  4. If the aircraft is airworthy, this statement or a similar one: "I certify that this aircraft has been inspected in accordance with (insert type) inspection and was determined to be in airworthy condition."

A sample built from those four items (example only; the names and numbers are placeholders):

[Date]. Aircraft total time [hours]. Annual inspection of airframe, engine and propeller performed using [checklist name], which includes the scope and detail of 14 CFR Part 43, Appendix D. I certify that this aircraft has been inspected in accordance with an annual inspection and was determined to be in airworthy condition. [Signature] [Name], A&P [certificate number], IA.

The entry can go in the airframe logbook or in each logbook (airframe, engine, propeller) as each is inspected; the rules don't require separate records (AC 43-9D).

When the airplane doesn't pass

  • If the aircraft isn't approved for return to service, the entry must say so with this statement or a similar one: "I certify that this aircraft has been inspected in accordance with (insert type) inspection and a list of discrepancies and unairworthy items dated (date) has been provided for the aircraft owner or operator." (43.11(a)(5)).
  • The inspector must give the owner a signed and dated list of those discrepancies (43.11(b)). FAA guidance says the list means that, except for those items, the aircraft was found airworthy (AC 43-9D).
  • Inoperative instruments or equipment that may stay inoperative under 14 CFR 91.213(d)(2) must be placarded "Inoperative" and added to the list (43.11(b)).
  • Keep the list until the items are repaired and the aircraft is approved for return to service (14 CFR 91.417(b)(3)), along with the entries for that work.
  • If an inspection is stopped before it's finished, FAA guidance says the record should clearly show it was discontinued (AC 43-9D).

Check your entry when you get the logbooks back

  • Is the date right, and is the total time the one your records use?
  • Does it name the type of inspection and describe its extent?
  • Is there a signature, certificate number and kind of certificate (for an annual, the IA)?
  • Does it carry the airworthy statement, or the discrepancy-list statement and a copy of the list?
  • Were ADs that came due recorded, and is your AD status list updated? See tracking AD compliance.
  • Was other work done at the same time (repairs, the ELT inspection) recorded too?

How GALogbook helps

  • Entries from the ramp: your A&P can text new work in, then review and sign it.
  • Labels for the paper logbook: print new entries on labels so the paper books match.
  • Find any annual fast: ask "When was the last annual and who signed it?" and see the page it came from.
Keep every annual one search away. Start the 7-day free trial and scan your logbooks.

Get started →   How to digitize your logbooks →

Sources